What Electronic Leak Detection Actually Finds
Acoustic listening equipment picks up the specific sound water makes escaping a pressurized line, which travels through pipe and surrounding material differently depending on depth and material type. Thermal imaging can reveal a temperature difference where water is saturating a wall or slab, especially useful for a hot water line leak where the temperature contrast against surrounding material is more pronounced.
Combined with pressure testing, which isolates sections of plumbing to narrow down which zone of the house actually has the leak, most leaks are located within a small, confirmed area before any cutting begins.
Signs Worth Getting Checked Before They Get Worse
A warm spot on an otherwise cool floor, especially over a slab, often means a hot water line leak underneath. The sound of running water when every fixture in the house is off is one of the clearest signs of a hidden leak anywhere in the system.
A water bill that jumps significantly with no change in household water use is worth investigating even without any visible sign, since a slow underground leak between the meter and the house can run for weeks before it surfaces.
Checking Your Own Meter Before You Call
Locate your water meter, usually near the street or in a basement utility area, and make sure every fixture and appliance that uses water is off, including ice makers and irrigation systems. Watch the small leak-indicator dial, often a red or black triangle, for a minute or two.
If it's moving at all with everything off, water is escaping somewhere in the system, and that observation alone is useful information to share with us when you call. Leak detection and any resulting repair work fall under our Delaware Public Health District plumbing registration, per the state standard set by Ohio House Bill 487.
Emergency Leak Detection: When a Leak Cannot Wait
A leak is an emergency when water is actively soaking a ceiling, pooling outside, or the meter is spinning fast with everything off. Shut off the main valve if you can reach it and call. We begin with the fastest test that tells you where the water is going.
Not every detection call is urgent. A slowly rising bill or a damp spot with no active drip can be scheduled, and the same tests apply either way.
Running Meter and High Water Bill Investigations
The most common reason people call for detection is a meter that keeps moving or a bill that jumped. Turn every fixture off and watch the low-flow dial on the meter. If it moves, water is leaving somewhere between the meter and the fixtures.
We then split the system into zones with pressure isolation, which separates a service line leak from an interior leak or an irrigation line. That narrows the search before any equipment touches a wall.
Ceiling, Wall, Crawlspace, and Underground Leaks
A stain on a ceiling or a damp wall often sits well away from the source, because water travels along framing before it shows. Thermal imaging and moisture mapping trace it back, and acoustic listening confirms a pressurized line.
Crawlspaces and basements allow direct inspection of supply lines. Buried lines, such as a service line or an irrigation supply, need electronic listening along the route. We mark the spot on the surface so the repair is a small, targeted excavation.
Irrigation, Hot Tub, and Outdoor Leaks
Irrigation zones fail at valves and fittings, and the symptom is often low pressure in one zone or a soft green patch of lawn. Hot tub and spa plumbing leaks are found by pressure testing the lines. A leak near an outdoor meter box or shutoff is checked at the connections first.
